Zenler Player
Your course is loading. Hang tight.
Back to Networking Basics Course
Back to curriculum
0% Complete
0% Complete
Intro to Course
OSI, DoD and Cisco Models
IEEE and Cabling Standards
Transmission Methods
Physical and Logical Topologies
Which Network Device should I use?
IPv4 Addresses
Subnetting in IPv4
Route Summarization
VLSM
Hexadecimal to Decimal Conversion
Main Components of a Router
How to navigate the CLI
Laz's Housekeeping Commands
Backing up Flash and Config to TFTP
The Spanning Tree Protocol
Using the VTP Protocol and Trunking Ports
How to create VLANs and ROAS
Understanding and Configuring RIP
Understanding and Configuring EIGRP
Understanding and Configuring OSPF
Understanding and Configuring BGP
Spine and Leaf Topology
Summary of Course
Introduction to Networking Basics
Intro to Course
Preview
Reference Models
OSI, DoD and Cisco Models
IEEE and Cabling Standards
Transmission Modes
Transmission Methods
Physical and Logical Topologies
Networking Devices and IPv4
Which Network Device should I use?
IPv4 Addresses
Subnetting in IPv4
Route Summarization
VLSM
Preview
Hex Conversions
Hexadecimal to Decimal Conversion
Cisco Router and Switch Fundamentals
Main Components of a Router
How to navigate the CLI
Cisco Router and Switch Configurations
Laz's Housekeeping Commands
Backing up Flash and Config to TFTP
Layer 2 Switching
The Spanning Tree Protocol
Using the VTP Protocol and Trunking Ports
How to create VLANs and ROAS
Dynamic Routing
Understanding and Configuring RIP
Understanding and Configuring EIGRP
Preview
Understanding and Configuring OSPF
Understanding and Configuring BGP
Layer 3 Routing using L3 Switching
Spine and Leaf Topology
Summary of Networking Basics
Summary of Course
Preview
×
This is an unpublished lesson. This lesson will not be shown for students unless you set it as Public.
Back to Dashboard
No contents are available in this lesson!
No lessons available !
Back to Dashboard
Lesson contents locked
Enroll to unlock this lesson.
Enroll to unlock
Next Lesson